Fulltext results:
- Exterior wall on floor slab @basics:building_physics_-_basics:thermal_bridges:tbcalculation:examples
- rier or sealing layers.// For the example given here, the bottom concrete layer (layer number 19) is d... de of the moisture barrier (layer number 17) and therefore has a poorer rated value for thermal conducti... ext{m}$). $B' = 7{,}992 \, \text{m}$ was selected here (including the exterior wall) //[Note: With some ... package |PHPP]] calculation. In the example shown here, the length of the exterior wall is 2.03 m. The b
- Heated basement @basics:building_physics_-_basics:thermal_bridges:tbcalculation:examples
- oned linear thermal transmittance is given below. Here it should be mentioned that in the Ground workshe... n system however, Option B should also be applied here for determining the Ψ-values. {{ :picopen:beheiz... f the exterior wall can also be calculated easily here from the U-value and the adopted length. The cond... n practice, pre-prepared Excel templates are used here also for determining the Ψ-values. The heat flows
- Unheated basement @basics:building_physics_-_basics:thermal_bridges:tbcalculation:examples
- As a rule, lower temperatures prevail in these, therefore thermal separation of the basement from the h... mperature $\theta_u$ of the basement is unknown, therefore $L_{2d}$ cannot be calculated directly, but ... ese may not be included in the U-value either. Therefore: <WRAP centeralign> $$ \dfrac{1}{U} = \dfrac... $L_{iu}$ were calculated with only 2 simulations here. In this case the desired heat flows must be dete
- Special features and characteristics of components in contact with the ground @basics:building_physics_-_basics:thermal_bridges:tbcalculation:ground_contact
- wards the surface through the building envelope, therefore the ground should be regarded as an additiona... Steady-state consideration of the heat flows is therefore quite adequate. This is no longer the case fo... 5 °C (on 21.07) in the test reference years shown here only has an impact 91 days later at a depth of 5 m. Here the peak temperature was still 13.1 °C on 20.10.
- Basic principle for calculating thermal bridges
- t. It is essential that the linear reference is adhered to all throughout. If interior references are us... plans and measurements. Exterior dimensions are therefore consistently used in the [[planning:tools|PHP... es are set for the inside and outside as long as there is a temperature decline due to the building comp... conductance and convection is combined in these, therefore they depend on the condition of the surfaces
- Interior walls on floor slabs @basics:building_physics_-_basics:thermal_bridges:tbcalculation:examples
- the interior wall is to the floor slab edge, and therefore to the exterior wall, the more on the safe si
- Recommended procedure for calculating thermal bridges of components in contact with the ground @basics:building_physics_-_basics:thermal_bridges:tbcalculation:ground_contact
- HPP uses the external dimensional reference everywhere for calculations the length of the floor slab sho