Fulltext results:
- Insulation vs. thermal mass
- rn wichtiger als Wärmedämmen? (Is thermal storage more important than thermal protection?) Passivhaus In... th very small energy gains, which is reduced even more by the heat radiation into the cold sky. However,... warm. The period of time spanned by the storage (more than 3 months) is much longer here than it is for... heat flows in the three space dimensions are even more important: These so-called thermal bridge effects
- Insulation works – Evidence no.1 "Measurements at a highly insulated wall"
- lot colder than the center of the brick and even more so than the interior surface. Yet, the temperatur... f the time period. However, this is not the case. More exact calculation results will only be obtained b... n for over a century, some of the early ones much more tricky than today’s. Today, the equation is used
- Outdoor thermography
- he insulation; otherwise the effect would be even more obvious.\\ \\ ==== The complete insulation ==== ... the window is no opened for a long time - see for more information the following Passipedia article: [[:
- Thermal protection in retrofits
- tem (red), which gives an energy\\ consumption of more than 200 kWh/(m²a) before the refur-\\ bishment (... dividual consumption is about 40 kWh/(m²a), still more than 80% less than the average consumption in the
- Energy use for heating in a well insulated new building
- ement ceiling hadn’t been completed. As a result, more energy (although still very little) was used duri... ment with calculations ===== There are currently more than **20,000 Passive House dwelling units in use
- Comparison of in-situ measurements and hygrothermal simulations of four different interior insulation systems @planning:thermal_protection:thermal_protection_works:comparison_of_in_situ_measurements_and_hygrothermal_simulations_of_four_different_interior_insulation_systems
- ch is checked in the following. \\ \\ ===== Read more ===== //The following in-depth articles are avai... Conclusions ===== After a measurement period of more than 2 years hygrothermal simulations using the m