Fulltext results:

Special features and characteristics of components in contact with the ground @basics:building_physics_-_basics:thermal_bridges:tbcalculation:ground_contact

6 Hits, Last modified: 3 years ago

ponent. However, the heat transfer resistance can no longer be determined in accordance with R = λ/d b... sequence, purely one-dimensional consideration is no longer sufficient. In order to take it into accou... e heat flows is therefore quite adequate. This is no longer the case for building components in contac... ual temperature is reached. The high phase shifts no longer allow a purely steady-state consideration

Software for calculating thermal bridges @basics:building_physics_-_basics:thermal_bridges:tbcalculation

2 Hits, Last modified: 3 years ago

dimensional with constant boundary conditions and no heat sources/sinks, an already known analytical s... 6]** Thermal bridge free design ; Protocol Volume No. 16 of the research Group for Cost-effective Pass

Definition and effects of thermal bridges

1 Hits, Last modified: 2 years ago

h good approximation. The reason for this is that no cross-flows occur in them on account of their hom

Thermal Bridges Catalogue

1 Hits, Last modified: 5 months ago

e, the best of our knowledge and belief. However, no liability can be accepted for any content-related

Unheated basement @basics:building_physics_-_basics:thermal_bridges:tbcalculation:examples

1 Hits, Last modified: 3 years ago

rnative procedure is given in the Protocol Volume No. 27 of the Research Group for Cost-effective Pass

Recommended procedure for calculating thermal bridges of components in contact with the ground @basics:building_physics_-_basics:thermal_bridges:tbcalculation:ground_contact

1 Hits, Last modified: 6 years ago

ll blocks of earth in the calculation models * no depiction of the ground, in a similar way to calc