Fulltext results:
- Definition and effects of thermal bridges
- thermal bridges on the energy balance depend not only on the influence in terms of physics but also on ... transmission losses of the building envelope can only be stated if the Ψ-values are calculated for a sp... is restricted. Cupboards and other furniture not only disrupt convection but also restrict radiant exch... t is solely related to thermal bridges. These are only the points where the problems originate in the fi
- Special features and characteristics of components in contact with the ground @basics:building_physics_-_basics:thermal_bridges:tbcalculation:ground_contact
- st formation, seepage and ground water. However, only the physical characteristics of the ground are re... ust 0.02 W/(m 2•K), so the relevant heat exchange only takes place towards the outside air. The heat flo... (on 21.07) in the test reference years shown here only has an impact 91 days later at a depth of 5 m. He... ional effort. Moreover, on account of the usually only imprecisely known thermal characteristics of the
- Exterior wall on floor slab @basics:building_physics_-_basics:thermal_bridges:tbcalculation:examples
- is not of any significance]//. The floor slab is only modelled up to the axis of symmetry and thus has ... ke the floor slab into account in the calculation only with its transfer resistance. For this, the trans... be aware that the Ψ-value shown here contains not only the geometric thermal bridge effect in the classi
- Unheated basement @basics:building_physics_-_basics:thermal_bridges:tbcalculation:examples
- fective Passive Houses and is demonstrated below. Only the conductances $L_{ie}$ and $L_{iu}$ are requi... riant, $L_{ie}$ and $L_{iu}$ were calculated with only 2 simulations here. In this case the desired heat... components in contact with the ground is reliable only to a certain extent because heat storage and phas
- Recommended procedure for calculating thermal bridges of components in contact with the ground @basics:building_physics_-_basics:thermal_bridges:tbcalculation:ground_contact
- he rows 55-58 which are hidden). These values can only be determined if the dimensions of the components... re known, because these specific U-values are not only dependent on their component build-up but also on... nally using an "infinitely" long analogous model (only two-dimensional heat flows). The previously menti
- Heated basement @basics:building_physics_-_basics:thermal_bridges:tbcalculation:examples
- the norms DIN EN ISO 13370 and DIN EN ISO 10211, only one Ψ-value is determined for a heated basement. ... lso possible; the consequence would be a (usually only slightly) different allocation of $\Psi_{overall}
- Thermal Bridges
- s|Minimising thermal bridges]] {{:picopen:members_only.png?20}} * {{:picopen:microsoft_word_-_05_fact
- Thermal Bridges Catalogue
- dges Catalogue - Full Version]]{{:picopen:members_only.png?nolink&20}}| For an even more precise identi
- Basic principle for calculating thermal bridges @basics:building_physics_-_basics:thermal_bridges:tbcalculation
- e temperature can then be read here; however this only refers to the respective temperature difference b