User Tools

Site Tools

You are here: Cloud Plugin » other
other

Search

You can find the results of your search below.

Fulltext results:

Heating load in Passive Houses
4 Hits, Last modified:
ly air distribution system will no longer require other heat distribution pipes and radiation systems in ... s. It was therefore desirable to make available another simple method for ascertaining the heating load, ... o various aspects, including heating consumption, other energy consumption figures, thermal comfort param... d, as such small influences are usually masked by other effects in buildings with high heating loads. \\
Exterior wall on floor slab @basics:building_physics_-_basics:thermal_bridges:tbcalculation:examples
3 Hits, Last modified:
relatively strongly negative Ψ-value is due among other things to the fact that the existing insulation s... dge effect in the classic sense but also includes other effects besides the insulation skirt. Thus, in th... e $f_{Rsi}$ factor, the same procedure as for any other thermal bridge can be used in this case as well.
Unheated basement @basics:building_physics_-_basics:thermal_bridges:tbcalculation:examples
3 Hits, Last modified:
on between the basement and the interior space, another Ψ-value must be calculated for the energy balance... eality is thus also depicted by the U-value among other things. ===== Procedure according to Protocol Vo... ature in the basement. On account of cabinets and other large items, the higher heat transfer resistance
Special features and characteristics of components in contact with the ground @basics:building_physics_-_basics:thermal_bridges:tbcalculation:ground_contact
3 Hits, Last modified:
with ground contact does not differ from that for other thermal bridges. However, it is helpful if the ef... the surface temperature is very difficult. Among other things, radiation exchange depends on the structu... teady-state Ψ-value one time, and equal to zero another time and then observing the influence on the fina
Recommended procedure for calculating thermal bridges of components in contact with the ground @basics:building_physics_-_basics:thermal_bridges:tbcalculation:ground_contact
3 Hits, Last modified:
the method according to DIN EN ISO 13370. On the other hand, this requires that thermal bridges should b... th Option A, the norm DIN EN ISO 10211 contains another possibility for calculating corresponding Ψ-value... essary for a two-dimensional dynamic calculation, otherwise three-dimensional transient calculation would
What defines thermal bridge free design?
2 Hits, Last modified:
tributions are compensated to a certain extent by other connections where there are negative linear therm... ign” that has often been mentioned here, numerous other details for building envelopes with thermal bridg
Definition and effects of thermal bridges @basics:building_physics_-_basics:thermal_bridges
2 Hits, Last modified:
ns are associated with an uncertainty of ca. 5 %, other methods such as the use of thermal bridge catalog... in corners and edges is restricted. Cupboards and other furniture not only disrupt convection but also re
Adaptive versus Heat Balance Comfort Models @basics:building_physics_-_basics:thermal_comfort
2 Hits, Last modified:
between indoor temperature and comfort vote in an otherwise uncontrolled field experiment is obviously wr... linear, particularly in the range of interest. Another important aspect of the RP-884 results is that **
Thermal comfort parameters @basics:building_physics_-_basics:thermal_comfort
2 Hits, Last modified:
p of temperature over this thermal resistance. In other words: * There is a smaller temperature differ... erior surface is only slightly different from the other indoor temperatures; this applies both in summer
Basic principle for calculating thermal bridges @basics:building_physics_-_basics:thermal_bridges:tbcalculation
2 Hits, Last modified:
rature can be performed using the same model, but other boundary conditions should be selected in each ca... nt heat flow through the building component among other things. A distinction is made between $R_{si}$ fo
Heated basement @basics:building_physics_-_basics:thermal_bridges:tbcalculation:examples
2 Hits, Last modified:
sider both these connections separately from each other. The ground represents a thermal connection betwe... ame procedure can be used in this case as for any other thermal bridge. <WRAP centeralign> **Determining
Heat transfer
1 Hits, Last modified:
ways from a warmer area towards a colder area, in other words: heat transfer always strives for an energy
Thermal bridge calculation @basics:building_physics_-_basics:thermal_bridges
1 Hits, Last modified:
uld growth. [{{ :picopen:kxtiso.png?nolink&200|Isothermenbild eines Balkonanschlusses}}] ====== Introd
Local thermal comfort @basics:building_physics_-_basics:thermal_comfort
1 Hits, Last modified:
in a smaller temperature loss at this surface, in other words: //the temperature difference between the i
Interior walls on floor slabs @basics:building_physics_-_basics:thermal_bridges:tbcalculation:examples
1 Hits, Last modified:
onductances with and without the interior wall. Another advantage is that the surface temperatures determ